If you want to get the most out of your electric scooter, it’s essential that you have a set of powerful lights to illuminate the road ahead. These can come in a range of shapes and sizes, but they all serve the same purpose: to help you see what’s around you at night or in dark conditions.
When choosing an electric scooter light, you’ll want to look for a few things: brightness, battery life, and IP protection. A light with good battery life can be used for longer periods of time than one with a low lumen output, which means that you’ll spend less money on power during your commute.
Lumens (lm) are the most important metric for light brightness, as they tell you how much light is emitted from a bulb. They are also useful for comparing different light bulbs.
Brightness varies significantly between different light bulbs, so it’s best to shop around for the highest output you can afford. In general, you should look for a light with a rated brightness of at least 1000 lumens.
You’ll typically need to use a light with a high-quality lens to ensure that it projects its beam of light as far as possible. This will allow you to be seen from further away and avoid dazzling other people on the road.
A high-quality lens will also make it easier for you to change between different modes – each of which has a varying level of brightness. Changing your mode allows you to adjust your light’s output and save on battery power.
Wiring up your electric scooter’s LED lights is a relatively simple task that requires basic DIY skills and some electrical know-how. Once you’ve finished, you’ll be able to ride your electric scooter with confidence and safety.
First, measure the length of all the wires on your electric scooter’s LED light strips. You should end up with a total of about six inches of positive and negative wire. You can cut the ends of each length to make them easier to work with if necessary. Next, connect each of the measured positive and negative wire leads to each of the LED strips with the supplied spade and terminal connectors.
Now that you’ve connected all the LED light strips, it’s time to solder the wiring together. The easiest way to do this is by using a crimping tool and a wire stripper, but if you don’t have these tools, you can easily solder the wires yourself.
Connect the positive wire to the positive terminal of your electric scooter’s battery first, then attach the negative wire to the negative terminal. Once this is done, you can flip the power switch to turn the lights on. If you have trouble connecting the wires, double check your connections and re-solder if needed.
Once you’ve completed the connection, flip the switch to turn the lights on and test them. If any of the lights aren’t working, it’s likely that they have a bad connection somewhere along the line.